The funny thing about pipes is that they have 2 ends.
If you are adding pressure pipes via the Content Catalog Editor and you happen to get the following error, "The following columns are required: 'Outer Diameter (mm),' 'Nominal Diameter (mm),' Joint End Type ID.' Please fill in the valid values and continue."
Don't forget to fill in data for both end of the pipe!
If you are adding pressure pipes via the Content Catalog Editor and you happen to get the following error, "The following columns are required: 'Outer Diameter (mm),' 'Nominal Diameter (mm),' Joint End Type ID.' Please fill in the valid values and continue."
Don't forget to fill in data for both end of the pipe!
No comments:
Post a Comment